Netgear XSM4324FS CLI Manual Software Version 12.x - Page 950

M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: This command causes a service to remove its reference to the policy. This command effectively disables DiffServ on an interface in the inbound direction or an interface in the outbound direction. There is no separate interface administrative 'mode' command for DiffServ. Format Modes no service-policy {in | out} policymapname Global Config Interface Config DiffServ Show Commands Use the DiffServ show commands to display configuration and status information for classes, policies, and services. You can display DiffServ information in summary or detailed formats. The status information is only shown when the DiffServ administrative mode is enabled. show class-map This command displays all configuration information for the specified class. The class-name is the name of an existing DiffServ class. Format Modes show class-map class-name Privileged EXEC User EXEC If the class-name is specified the following fields are displayed. Term Class Name Class Type Class Layer3 Protocol Match Criteria Values Definition The name of this class. A class type of all means every match criterion defined for the class is evaluated simultaneously and must all be true to indicate a class match. The Layer 3 protocol for this class. Possible values are IPv4 and IPv6. The Match Criteria fields are only displayed if they have been configured. Not all platforms support all match criteria values. They are displayed in the order entered by the user. The fields are evaluated in accordance with the class type. The possible Match Criteria fields are: Destination IP Address, Destination Layer 4 Port, Destination MAC Address, Ethertype, Source MAC Address, VLAN, Class of Service, Every, IP DSCP, IP Precedence, IP TOS, Protocol Keyword, Reference Class, Source IP Address, and Source Layer 4 Port. The values of the Match Criteria. Quality of Service Commands 950 CLI Command Reference Manual