Netgear XSM4324FS CLI Manual Software Version 12.x - Page 969

M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter [assign-queue queue-id] [{mirror | redirect} {unit/slot/port | lag lag-group-id}] [rate-limit rate burst-size] Description Specifies the assign-queue, which is the queue identifier to which packets matching this rule are assigned. Specifies the mirror or redirect interface that is the unit/slot/port or lag-group-id to which packets matching this rule are copied or forwarded. Specifies the allowed rate of traffic as per the configured rate in kbps, and burst-size in kbytes. no access-list This command deletes an IP ACL that is identified by the parameter accesslistnumber from the system. The range for accesslistnumber is 1-99 for standard access lists and 100-199 for extended access lists. Format Mode no access-list accesslistnumber Global Config ip access-list This command creates an extended IP Access Control List (ACL) identified by name, consisting of classification fields defined for the IP header of an IPv4 frame. The name parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access list. The rate-limit attribute configures the committed rate and the committed burst size. If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode to allow updating the existing IP ACL. Note: The CLI mode changes to IPv4-Access-List Config mode when you successfully execute this command. Format Mode ip access-list name Global Config no ip access-list This command deletes the IP ACL identified by name from the system. Format Mode no ip access-list name Global Config Quality of Service Commands 969 CLI Command Reference Manual