Netgear XSM4324FS CLI Manual Software Version 12.x - Page 298
debug lacp packet, debug mldsnooping packet
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 298 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches control packet type, packet length, and the interface on which the packet is received or transmitted is displayed on the console. Note: To display the debug trace, enable the debug console command. Default Format Mode disabled debug ipv6 pimsm packet [receive | transmit] Privileged EXEC no debug ipv6 pimsm packet Use this command to disable debug tracing of PIMSMv6 packet reception and transmission. Format Mode no debug ipv6 pimsm packet [receive | transmit] Privileged EXEC debug lacp packet This command enables tracing of LACP packets received and transmitted by the switch. Note: To display the debug trace, enable the debug console command. Default Format Mode disabled debug lacp packet Privileged EXEC The following sample shows the output of the trace message. JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %% Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key: 0x36 no debug lacp packet This command disables tracing of LACP packets. Format Mode no debug lacp packet Privileged EXEC debug mldsnooping packet Use this command to trace MLD snooping packet reception and transmission. The receive keyword traces only received MLD packets and the transmit keyword traces only transmitted MLD snooping packets. When neither keyword is used in the command, then all MLD snooping packet traces are dumped. Vital information such as source address, Utility Commands 298 CLI Command Reference Manual