Netgear XSM4324FS CLI Manual Software Version 12.x - Page 657
ip routing, ip address, The 31-bit subnet mask is only supported on routing interfaces.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 657 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches ip routing This command enables the IP Router Admin Mode for the switch. Format Mode ip routing Global Config no ip routing This command disables the IP Router Admin Mode for the switch. Format Mode no ip routing Global Config ip address This command configures an IP address on an interface or range of interfaces. You can also use this command to configure one or more secondary IP addresses on the interface. The command supports RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds the label IP address in the command show ip interface on page 667. Note: The 31-bit subnet mask is only supported on routing interfaces. The feature is not supported on network port and service port interfaces because the switch acts as a host, not a router, on these management interfaces. Format Mode ip address ipaddr {subnetmask | /masklen} [secondary] Interface Config Parameter Description ipaddr The IP address of the interface. subnetmask A 4-digit dotted-decimal number which represents the subnet mask of the interface. masklen Implements RFC 3021. Using the / notation of the subnet mask, this is an integer that indicates the length of the subnet mask. Range is 5 to 32 bits. Command example: The following example configures the subnet mask with an IP address in the dotted decimal format on interface 0/4/1. (NETGEAR Switch) #config (NETGEAR Switch) (Config)#interface 0/4/1 (NETGEAR Switch) (Interface 0/4/1)#ip address 192.168.10.1 255.255.255.254 Routing Commands 657 CLI Command Reference Manual