Netgear XSM4324FS CLI Manual Software Version 12.x - Page 73

M4300 Intelligent Edge Series Fully Managed Stackable Switches ip telnet port Use this command to configure the TCP port number on which the Telnet server detects requests. The number argument can be a port number in the range from 1 to 65535. Default Format Mode 23 ip telnet port number Privileged EXEC no ip telnet port Use this command to reset the TCP port number on which the Telnet server detects requests to the default of 23. Format Mode no ip telnet port Privileged EXEC telnet This command establishes a new outbound Telnet connection to a remote host. The host must be a valid IP address or host name. Valid values for port should be a valid decimal integer in the range of 0 to 65535, where the default value is 23. If debug is used, the current Telnet options enabled is displayed. The optional line parameter sets the outbound Telnet operational mode as linemode where, by default, the operational mode is character mode. The localecho option enables local echo. Format Modes telnet {ip-address | hostname} port [debug] [line] [localecho] • Privileged EXEC • User EXEC transport input telnet This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established until there are no more sessions available. An established session remains active until the session is ended or an abnormal network error ends the session. Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established. Use the ip telnet server enable command to enable Telnet Server Admin Mode. Default Format Mode enabled transport input telnet Line Config Management Commands 73 CLI Command Reference Manual