Netgear XSM4324FS CLI Manual Software Version 12.x - Page 740

M4300 Intelligent Edge Series Fully Managed Stackable Switches defaults to the actual interface bandwidth for port-based routing interfaces and to 10 Mbps for VLAN routing interfaces. This command does not affect the actual speed of an interface. You can use this command to configure a single interface or a range of interfaces. Default Format Mode actual interface bandwidth bandwidth kbps Interface Config no bandwidth Use this command to set the interface bandwidth to its default value. Format Mode no bandwidth Interface Config ip ospf authentication This command sets the OSPF authentication type and key for the specified interface or range of interfaces. The type of authentication can be either none, simple, or encrypt. If you select simple or encrypt, the key parameter is composed of standard displayable, noncontrol keystrokes from a standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key can be up to 16 bytes. Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a keyid in the range of 0 and 255 must be specified. The default value for authentication type is none. Neither the default password key nor the default key id are configured. Format Mode ip ospf authentication {none | simple key | encrypt key keyid} Interface Config no ip ospf authentication This command resets the default OSPF authentication type for the interface. Format Mode no ip ospf authentication Interface Config Routing Commands 740 CLI Command Reference Manual