Netgear XSM4324FS CLI Manual Software Version 12.x - Page 842
clear ipv6 neighbors, show ipv6 protocols, tunnel
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 842 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The tunnel keyword with the number variable specifies the IPv6 tunnel interface and is a number in the range 0-7. Format Mode show ipv6 neighbor [interface {unit/slot/port | vlan vlan-id | tunnel number | ipv6-address] Privileged EXEC Term Interface IPv6 Address MAC Address IsRtr Neighbor State Last Updated Type Definition The interface in unit/slot/port format. IPV6 address of neighbor or interface. Link-layer Address. Shows whether the neighbor is a router. If the value is TRUE, the neighbor is known to be a router, and FALSE otherwise. A value of FALSE might mean that routers are not always known to be routers. State of neighbor cache entry. Possible values are Incomplete, Reachable, Stale, Delay, Probe, and Unknown. The time in seconds that has elapsed since an entry was added to the cache. The type of neighbor entry. The type is Static if the entry is manually configured and Dynamic if dynamically resolved. clear ipv6 neighbors Use this command to clear all entries IPv6 neighbor table or an entry on a specific interface. Use the optional unit/slot/port parameter to specify an interface. Format Mode clear ipv6 neighbors [unit/slot/port] Privileged EXEC show ipv6 protocols This command lists a summary of the configuration and status for the active IPv6 routing protocols. The command lists routing protocols that are configured and enabled. If a protocol is selected on the command line, the display is limited to that protocol. Format Mode show ipv6 protocols [bgp | ospf] Privileged Exec Parameter BGP Section: Routing Protocol Router ID Description BGP. The router ID configured for BGP. IPv6 Commands 842 CLI Command Reference Manual