Netgear XSM4324FS CLI Manual Software Version 12.x - Page 186

M4300 Intelligent Edge Series Fully Managed Stackable Switches boot host autosave Use this command to automatically save the downloaded configuration file to the startup-config file on the switch. When autosave is disabled, you must explicitly save the downloaded configuration to non-volatile memory by using the write memory or copy system:running-config nvram:startup-config command. If the switch reboots and the downloaded configuration has not been saved, the AutoInstall process begins, if the feature is enabled. Default Format Mode disabled boot host autosave Privileged EXEC no boot host autosave Use this command to disable automatically saving the downloaded configuration on the switch. Format Mode no boot host autosave Privileged EXEC boot host autoreboot Use this command to allow the switch to automatically reboot after successfully downloading an image. When auto reboot is enabled, no administrative action is required to activate the image and reload the switch. Default Format Mode enabled boot host autoreboot Privileged EXEC no boot host autoreboot Use this command to prevent the switch from automatically rebooting after the image is downloaded by using the AutoInstall feature. Format Mode no boot host autoreboot Privileged EXEC erase startup-config Use this command to erase the text-based configuration file stored in non-volatile memory. If the switch boots and no startup-config file is found, the AutoInstall process automatically begins. Utility Commands 186 CLI Command Reference Manual