Netgear XSM4324FS CLI Manual Software Version 12.x - Page 71
serial timeout, set sup-console, no serial baudrate
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no serial baudrate This command sets the communication rate of the terminal interface. Format Mode no serial baudrate Line Config serial timeout This command specifies the maximum connect time (in minutes) without console activity. A value of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160. Default Format Mode 5 serial timeout 0-160 Line Config no serial timeout This command sets the maximum connect time (in minutes) without console activity. Format Mode no serial timeout Line Config set sup-console This command allows access to the full CLI from any member. By default, the master is allowed full CLI access. You can move full CLI access among the members, but at any time, only one member can access the management CLI. You can issue the command on the member or backup unit. After the console is transferred to the backup unit or to a member unit, access to the full CLI on the master is disabled to avoid multiple simultaneous CLI inputs. You can restore full access on the master by entering the command at the master serial port. Note: If you enter the command while the master is already allowed full CLI access, the command does not take effect. Format Mode set sup-console Privileged EXEC Management Commands 71 CLI Command Reference Manual