Netgear XSM4324FS CLI Manual Software Version 12.x - Page 485

M4300 Intelligent Edge Series Fully Managed Stackable Switches Format Mode no storm-control multicast action Global Config Interface Config storm-control multicast level This command configures the multicast storm recovery threshold for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) as a percentage of link speed and enables multicast storm recovery mode. If the mode is enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of multicast traffic will be limited to the configured threshold. The threshold level can be in the range from 0-100. The default is 5. Default Format Mode 5 storm-control multicast level 0-100 Global Config Interface Config no storm-control multicast level This command sets the multicast storm recovery threshold to the default value for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) and disables multicast storm recovery. Format Mode no storm-control multicast level Global Config Interface Config storm-control multicast rate Use this command to configure the multicast storm recovery threshold for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) in packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured threshold. The threshold rate can be in the range from 0-14880000. The default is 0. Default Format Mode 0 storm-control multicast rate threshold Global Config Interface Config Switching Commands 485 CLI Command Reference Manual