Netgear XSM4324FS CLI Manual Software Version 12.x - Page 585

M4300 Intelligent Edge Series Fully Managed Stackable Switches set mld mrouter Use this command to configure the VLAN ID for the VLAN that has the multicast router attached mode enabled. Format Mode set mld mrouter vlan-id Interface Config no set mld mrouter Use this command to disable multicast router attached mode for a VLAN with a particular VLAN ID. Format Mode no set mld mrouter vlan-id Interface Config set mld mrouter interface Use this command to configure the interface as a multicast router-attached interface. When configured as a multicast router interface, the interface is treated as a multicast router-attached interface in all VLANs. Default Format Mode disabled set mld mrouter interface Interface Config no set mld mrouter interface Use this command to disable the status of the interface as a statically configured multicast router-attached interface. Format Mode no set mld mrouter interface Interface Config set mld exclude-mrouter-intf Use this command to control whether unknown multicast data is sent to an mrouter interface. If either IGMP Snooping or MLD Snooping is enabled on a VLAN, by default, dynamic mrouter mode is enabled on the interface that receives MLD PDUs from the upstream router. When the mrouter mode is enabled on the interface, unknown multicast data is sent to that interface. If you enter the command, the switch blocks all unknown multicast data through the mrouter port, whether the port is configured dynamically or statically. Only MLD PDUs are allowed to pass through the mrouter port to the upstream router interface. Switching Commands 585 CLI Command Reference Manual