Netgear XSM4324FS CLI Manual Software Version 12.x - Page 819
tunnel mode ipv6ip, show interface tunnel, address and tunnel destination address.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 819 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches tunnel mode ipv6ip This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel mode is set to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is configured. Format Mode tunnel mode ipv6ip [6to4] Interface Config show interface tunnel This command displays the parameters related to tunnel such as tunnel mode, tunnel source address and tunnel destination address. Format Mode show interface tunnel [tunnel-id] Privileged EXEC If you do not specify a tunnel ID, the command shows the following information for each configured tunnel. Term Tunnel ID Interface Tunnel Mode Source Address Destination Address Definition The tunnel identification number. The name of the tunnel interface. The tunnel mode. The source transport address of the tunnel. The destination transport address of the tunnel. If you specify a tunnel ID, the command shows the following information for the tunnel. Term Interface Link Status MTU Size IPv6 Address/Length Definition Shows whether the link is up or down. The maximum transmission unit for packets on the interface. If you enable IPv6 on the interface and assign an address, the IPv6 address and prefix display. IPv6 Commands 819 CLI Command Reference Manual