Netgear XSM4324FS CLI Manual Software Version 12.x - Page 602

M4300 Intelligent Edge Series Fully Managed Stackable Switches lldp receive Use this command to enable the LLDP receive capability on an interface or a range of interfaces. Default Format Mode disabled lldp receive Interface Config no lldp receive Use this command to return the reception of LLDPDUs to the default value. Format Mode no lldp receive Interface Config lldp timers Use this command to set the timing parameters for local data transmission on ports enabled for LLDP. The interval-seconds determines the number of seconds to wait between transmitting local data LLDPDUs. The range is 1-32768 seconds. The hold-value is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier range is 2-10. The reinit-seconds is the delay before reinitialization, and the range is 1-0 seconds. Default Format Mode interval-30 seconds hold-4 reinit-2 seconds lldp timers [interval interval-seconds] [hold hold-value] [reinit reinit-seconds] Global Config no lldp timers Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to the default values. Format Mode no lldp timers [interval] [hold] [reinit] Global Config lldp transmit-tlv Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are transmitted in the LLDPDUs from an interface or range of interfaces. Use sys-name to transmit the system name TLV. Switching Commands 602 CLI Command Reference Manual