Netgear XSM4324FS CLI Manual Software Version 12.x - Page 423

M4300 Intelligent Edge Series Fully Managed Stackable Switches vlan protocol group add protocol This command adds the protocol to the protocol-based VLAN identified by groupid. A group may have more than one protocol associated with it. Each interface and protocol combination can only be associated with one group. If adding a protocol to a group causes any conflicts with interfaces currently associated with the group, this command fails and the protocol is not added to the group. The possible values for protocol-list includes the keywords ip, arp, and ipx and hexadecimal or decimal values ranging from 0x0600 (1536) to 0xFFFF (65535). The protocol list can accept up to 16 protocols separated by a comma. Default Format Mode none vlan protocol group add protocol groupid ethertype protocol-list Global Config no vlan protocol group add protocol This command removes the protocols specified in the protocol-list from this protocol-based VLAN group that is identified by this groupid. Format Mode no vlan protocol group add protocol groupid ethertype protocol-list Global Config protocol group This command attaches a vlanid to the protocol-based VLAN identified by groupid. A group can only be associated with one VLAN at a time, however the VLAN association can be changed. Default Format Mode none protocol group groupid vlanid VLAN Config no protocol group This command removes the vlanid from this protocol-based VLAN group that is identified by this groupid. Format Mode no protocol group groupid vlanid VLAN Config protocol vlan group This command adds a physical interface or a range of interfaces to the protocol-based VLAN identified by groupid. You can associate multiple interfaces with a group, but you can only Switching Commands 423 CLI Command Reference Manual