Netgear XSM4324FS CLI Manual Software Version 12.x - Page 436

M4300 Intelligent Edge Series Fully Managed Stackable Switches no mode dvlan-tunnel This command is used to disable Double VLAN Tunneling on the specified interface. By default, Double VLAN Tunneling is disabled. Format Mode no mode dvlan-tunnel Interface Config show dot1q-tunnel Use this command without the optional parameters to display all interfaces enabled for Double VLAN Tunneling. Use the optional parameters to display detailed information about Double VLAN Tunneling for the specified interface or all interfaces. Format Mode show dot1q-tunnel [interface {unit/slot/port | all}] Privileged EXEC User EXEC Term Interface Mode EtherType Definition The interface. The administrative mode through which Double VLAN Tunneling can be enabled or disabled. The default value for this field is disabled. A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are three different EtherType tags. The first is 802.1Q, which represents the commonly used value of 0x8100. The second is vMAN, which represents the commonly used value of 0x88A8. If EtherType is not one of these two values, then it is a custom tunnel value, representing any value in the range of 1 to 65535. show dvlan-tunnel Use this command without the optional parameters to display all interfaces enabled for Double VLAN Tunneling. Use the optional parameters to display detailed information about Double VLAN Tunneling for the specified interface or all interfaces. Format Mode show dvlan-tunnel [interface {unit/slot/port | all | lag lag-intf-num}] Privileged EXEC User EXEC Term Interface LAG Definition The interface. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number. Switching Commands 436 CLI Command Reference Manual