Netgear XSM4324FS CLI Manual Software Version 12.x - Page 724
no area range, advertise, not-advertise]
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 724 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter not-advertise cost Description [Optional] When this keyword is given, neither the summary prefix nor the contained prefixes are advertised when the area range is active. When the not-advertise option is given, any static cost previously configured is removed from the system configuration. [Optional] If an optional cost is given, OSPF sets the metric field in the summary LSA to the configured value rather than setting the metric to the largest cost among the networks covered by the area range. A static cost may only be configured if the area range is configured to advertise the summary. The range is 0 to 16,777,215. If the cost is set to 16,777,215 for type 3 summarization, a type 3 summary LSA is not advertised, but contained networks are suppressed. This behavior is equivalent to specifying the not-advertise option. If the range is configured for type 7 to type 5 translation, a type 5 LSA is sent if the metric is set to 16,777,215; however, other routers will not compute a route from a type 5 LSA with this metric. no area range The no area range command deletes a specified area range or reverts an option to its default. Format Mode no area area-id range prefix netmask {summarylink | nssaexternallink} [advertise | not-advertise] [cost] OSPFv2 Router Configuration Command example: !! Create area range (NETGEAR Switch) (Config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink !! Delete area range (NETGEAR Switch) (Config-router)#no area 1 range 10.0.0.0 255.0.0.0 summarylink You can use the no area range command to revert the [advertise | not-advertise] option to its default without deleting the area range. Deleting and recreating the area range would cause OSPF to temporarily advertise the prefixes contained within the range. Note that using either the advertise or not-advertise keyword reverts the configuration to the default. For example: !! Create area range. Suppress summary. (NETGEAR Switch) (Config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink not-advertise !! Advertise summary. (NETGEAR Switch) (Config-router)#no area 1 range 10.0.0.0 255.0.0.0 summarylink not-advertise You can also use the no area range command to remove a static area range cost, so that OSPF sets the cost to the largest cost among the contained routes. !! Create area range with static cost. (NETGEAR Switch) (Config-router)#area 1 range 10.0.0.0 255.0.0.0 summarylink cost 1000 !! Remove static cost. Routing Commands 724 CLI Command Reference Manual