Netgear XSM4324FS CLI Manual Software Version 12.x - Page 940

M4300 Intelligent Edge Series Fully Managed Stackable Switches ToS field in a packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit 1 clear, where bit 7 is most significant, use a tosbits value of a0 (hex) and a tosmask of a2 (hex). Use the not option to negate the match condition. Note: The IP DSCP, IP Precedence, and IP ToS match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Note: This free form version of the IP DSCP/Precedence/ToS match specification gives the user complete control when specifying which bits of the IP Service Type field are checked. Default Format Mode none match [not] ip tos tosbits tosmask Class-Map Config match ip6flowlbl Use this command to enter an IPv6 flow label value. Use the not option to negate the match condition. The value argument can be in the range of 0-1048575. Default Format Mode none match [not] ip6flowlbl label value IPv6-Class-Map Config match protocol This command adds to the specified class definition a match condition based on the value of the IP Protocol field in a packet using a single keyword notation or a numeric value notation. To specify the match condition using a single keyword notation, the value for protocol-name is one of the supported protocol name keywords. The currently supported values are: icmp, igmp, ip, tcp, udp. A value of ip matches all protocol number values. To specify the match condition using a numeric value notation, the protocol number argument is a standard value assigned by IANA and is interpreted as an integer from 0 to 255. Use the [not] option to negate the match condition. Note: This command does not validate the protocol number value against the current list defined by IANA. Quality of Service Commands 940 CLI Command Reference Manual