Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1065
ipv6 pim join-prune-interval, no ipv6 pim dr-priority
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1065 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default 1 Format ipv6 pim dr-priority priority Mode Interface Config Command example: (NETGEAR) (Interface 1/0/1) #ipv6 pim dr-priority 10 no ipv6 pim dr-priority Use this command to return the DR Priority on the specified interface to its default value. Format Mode no ipv6 pim dr-priority Interface Config ipv6 pim join-prune-interval This command is used to configure the join/prune interval for the PIM-SM router on an interface or range of interfaces. The join/prune interval is specified in seconds. The seconds argument can be configured as a value from 0 to 18000 seconds. Note: This command takes effect only when PIM-SM is enabled in the Global mode. Default Format Mode 60 ipv6 pim join-prune-interval seconds Interface Config Command example: The following shows examples of the command. (NETGEAR) (Interface 1/0/1) #ipv6 pim join-prune-interval 90 no ipv6 pim join-prune-interval Use this command to set the join/prune interval on the specified interface to the default value. Format Mode no ipv6 pim join-prune-interval Interface Config IPv6 Multicast Commands 1065 CLI Command Reference Manual