Netgear XSM4324FS CLI Manual Software Version 12.x - Page 732

M4300 Intelligent Edge Series Fully Managed Stackable Switches no distance ospf This command resets the default route preference value of OSPF routes in the router. The type of OSPF route can be intra-area, inter-area, or external. Format Mode no distance ospf {intra-area | inter-area | external} Router OSPF Config distribute-list out (OSPF) Use this command to specify the access list to filter routes received from the source protocol. The access-list argument can be a number from 1-199. Format Mode distribute-list access-list out {rip | bgp | static | connected} Router OSPF Config no distribute-list out Use this command to reset the access list to filter routes received from the source protocol. Format Mode no distribute-list access-list out {rip | bgp | static | connected} Router OSPF Config exit-overflow-interval (OSPF) This command configures the exit overflow interval for OSPF. It describes the number of seconds after entering overflow state that a router will wait before attempting to leave the overflow state. This allows the router to again originate nondefault AS-external-LSAs. When set to 0, the router will not leave overflow state until restarted. The range for the seconds argument is 0 to 2147483647 seconds. Default Format Mode 0 exit-overflow-interval seconds Router OSPF Config no exit-overflow-interval This command configures the default exit overflow interval for OSPF. Format Mode no exit-overflow-interval Router OSPF Config Routing Commands 732 CLI Command Reference Manual