Netgear XSM4324FS CLI Manual Software Version 12.x - Page 673

M4300 Intelligent Edge Series Fully Managed Stackable Switches Redistribution: Source Metric Dist List Match connected 6 static 10 15 ospf 20 int ext1 ext2 nssa-ext1 Interface Send Recv --------- ---- ---- 0/25 RIPv2 RIPv2 show ip route This command displays the routing table. The ip-address specifies the network for which the route is to be displayed and displays the best matching best-route for the address. The mask specifies the subnet mask for the given ip-address. When you use the longer-prefixes keyword, the ip-address and mask pair becomes the prefix, and the command displays the routes to the addresses that match that prefix. Use the protocol parameter to specify the protocol that installed the routes. The value for protocol can be connected, ospf, rip, static, or bgp. Use the all parameter to display all routes including best and nonbest routes. If you do not use the all parameter, the command displays only the best route. Note: If you use the connected keyword for protocol, the all option is not available because there are no best or nonbest connected routes. Note: If you use the static keyword for protocol, the description option is also available, for example: show ip route ip-address static description. This command shows the description configured with the specified static route(s). Format Modes show ip route [{ip-address [protocol] | {ip-address mask [longer-prefixes] [protocol] | protocol} [all] | all}] Privileged EXEC User EXEC Term Route Codes Definition The key for the routing protocol codes that might appear in the routing table output. The show ip route command displays the routing tables in the following format: Code IP-Address/Mask [Preference/Metric] via Next-Hop, Route-Timestamp, Interface, Truncated Routing Commands 673 CLI Command Reference Manual