Netgear XSM4324FS CLI Manual Software Version 12.x - Page 136

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Client IP Mask Access Mode Status Definition A mask to be ANDed with the requesting entity's IP address before comparison with IP address. If the result matches with IP address then the address is an authenticated IP address. For example, if the IP address = 9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming IP address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0. The access level for this community string. The status of this community access entry. show snmptrap This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP network manager. These messages alert the manager to events occurring within the switch or on the network. Six trap receivers are simultaneously supported. Format Mode show snmptrap Privileged EXEC Term SNMP Trap Name IP Address IPv6 Address SNMP Version Status Definition The community string of the SNMP trap packet sent to the trap manager. The string is case-sensitive and can be up to 16 alphanumeric characters. The IPv4 address to receive SNMP traps from this device. The IPv6 address to receive SNMP traps from this device. SNMPv2 The receiver's status (enabled or disabled). Command example: (NETGEAR Switch)#show snmptrap Community Name IpAddress Mytrap 0.0.0.0 IPv6 Address 2001::1 Snmp Version SNMPv2 Mode Enable show trapflags show trapflags This command displays the trap conditions. The command output shows all enabled trap flags, including OSPFv2 and OSPFv3 trap flags. Management Commands 136 CLI Command Reference Manual