Netgear XSM4324FS CLI Manual Software Version 12.x - Page 704

M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip vrrp timers advertise This command sets the default virtual router advertisement value for an interface or range of interfaces. The parameter vrid is the virtual router ID which has an integer value ranges from 1 to 255. Format Mode no ip vrrp vrid timers advertise Interface Config ip vrrp track interface Use this command to alter the priority of the VRRP router based on the availability of its interfaces. This command is useful for tracking interfaces that are not configured for VRRP. The parameter vrid is the virtual router ID which has an integer value ranges from 1 to 255. Only IP interfaces are tracked. A tracked interface is up if the IP on that interface is up. Otherwise, the tracked interface is down. You can use this command to configure a single interface or range of interfaces. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vlan-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in a unit/slot/port format. The vlan-id can be a number from 1-4093. When the tracked interface is down or the interface has been removed from the router, the priority of the VRRP router will be decremented by the value specified in the priority argument. When the interface is up for IP protocol, the priority will be incremented by the priority value. A VRRP configured interface can track more than one interface. When a tracked interface goes down, then the priority of the router will be decreased by 10 (the default priority decrement) for each downed interface. The default priority decrement is changed using the priority argument. The default priority of the virtual router is 100, and the default decrement priority is 10. By default, no interfaces are tracked. If you specify just the interface to be tracked, without giving the optional priority, then the default priority will be set. The default priority decrement is 10. Default Format Mode priority: 10 ip vrrp vrid track interface {unit/slot/port | vlan vlan-id} [decrement priority] Interface Config no ip vrrp track interface Use this command to remove the interface or range of interfaces from the tracked list or to restore the priority decrement to its default. The parameter vrid is the virtual router ID which has an integer value ranges from 1 to 255. Format Mode no ip vrrp vrid track interface {unit/slot/port | vlan vlan-id} [decrement] Interface Config Routing Commands 704 CLI Command Reference Manual