Netgear XSM4324FS CLI Manual Software Version 12.x - Page 997

M4300 Intelligent Edge Series Fully Managed Stackable Switches 0/4 Disabled Down 0/5 Disabled Down show auto-voip oui-table Use this command to display the VoIP OUI table information. Format Mode show auto-voip oui-table Privileged EXEC Parameter OUI Status OUI Description Description OUI of the source MAC address. Default or configured entry. Description of the OUI. Command example: (NETGEAR Switch)# show auto-voip oui-table OUI --------00:01:E3 00:03:6B 00:01:01 Status ---------Default Default Configured Description --------SIEMENS CISCO1 VoIP phone iSCSI Optimization Commands This section describes commands you use to monitor iSCSI sessions and prioritize iSCSI packets. iSCSI Optimization provides a means of giving traffic between iSCSI initiator and target systems special Quality of Service (QoS) treatment. This is accomplished by monitoring traffic to detect packets used by iSCSI stations to establish iSCSI sessions and connections. Data from these exchanges is used to create classification rules that assign the traffic between the stations to a configured traffic class. Packets in the flow are queued and scheduled for egress on the destination port based on these rules. iscsi aging time This command sets the aging time for iSCSI sessions. Behavior when changing aging time: • When aging time is increased, current sessions will be timed out according to the new value. • When aging time is decreased, any sessions that have been dormant for a time exceeding the new setting will be immediately deleted from the table. All other sessions will continue to be monitored against the new time out value. Quality of Service Commands 997 CLI Command Reference Manual