Netgear XSM4324FS CLI Manual Software Version 12.x - Page 359

M4300 Intelligent Edge Series Fully Managed Stackable Switches You can receive the statistics in the following ways: • User requests through the CLI for a set of counters. • Configuring the device to display statistics using syslog or email alert. The syslog or email alert messages are sent by the statistics application at END time. You can configure the device to display statistics on the console. The collected statistics are presented on the console at END time. stats group (Global Config) This command creates a new group with the specified id or name and configures the time range and the reporting mechanism for that group. Format Mode stats group group-id | name timerange time-range name reporting list-of-reporting-methods Global Config Parameter group ID, name time range name list of reporting methods Description Name of the group of statistics or its identifier to apply on the interface. The range is: • 1. received • 2. received-errors • 3. transmitted • 4. transmitted-errors • 5. received-transmitted • 6. port-utilization • 7. congestion The default is None. Name of the time range for the group or the flow-based rule. The range is 1 to 31 alphanumeric characters. The default is None. Report the statistics to the configured method. The range is: • 0. none • 1. console • 2. syslog • 3. e-mail The default is None. Command example: (NETGEAR Switch) (Config)# stats group received timerange test reporting console email syslog (NETGEAR Switch) (Config)# stats group received-errors timerange test reporting email syslog (NETGEAR Switch) (Config)# stats group received- transmitted timerange test reporting none Utility Commands 359 CLI Command Reference Manual