Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1095

M4300 Intelligent Edge Series Fully Managed Stackable Switches poe priority Use this command to configure the priority on a specific port. This is used for power management purposes. The switch might not be able to supply power to all connected devices, so the port priority is used to determine which ports will supply power if adequate power capacity is not available for all enabled ports. For ports that have the same priority level, the lower numbered port will have higher priority. If a switch delivers peak power to a number of devices and you attach a new device to a high-priority port, the switch can shut down power to a low-priority port before it powers up the new device. no poe priority Use this command to set the priority to the default. Format Mode no poe priority Interface Config poe reset Use this command to reset the PoE state of every port (in global mode) or a specific port (in interface mode). When the PoE port status is shown to be in an error state, this command can be used to reset the PoE port. The command can also reset the power-delivering ports. Note that this command takes effect only once after it is executed and cannot be saved across power cycles. Format Mode poe reset Global Config Interface Config poe timer schedule Use this command to allow you to attach a timer schedule to a PoE port. You can define a time schedule using the existing time range commands. This schedule has start and stop times. When this timer schedule is applied to a PoE-enabled port, the capability of the port to deliver power is affected. At the scheduled start time, the PoE port is disabled such that it cannot deliver any power. At the scheduled stop time, the PoE port is reenabled so that it can deliver power. Note: For information about creating a timer schedule, see Time Range Commands for Time-Based ACLs on page 990. Format Mode poe timer schedule name Interface Config Power over Ethernet Commands 1095 CLI Command Reference Manual