Netgear XSM4324FS CLI Manual Software Version 12.x - Page 107

M4300 Intelligent Edge Series Fully Managed Stackable Switches as the snmpv3 encryption password, so it must be a minimum of eight characters. If you select none, you do not need to provide a key. The username value is the login user name associated with the specified encryption. You must enter the username in the same case you used when you added the user. To see the case of the user name, enter the show users command. Default Format Mode no encryption username snmpv3 encryption username {none | des [key]} Global Config no username snmpv3 encryption This command sets the encryption protocol to none. The username is the login user name for which the specified encryption protocol will be used. Format Mode no username snmpv3 encryption username Global Config username snmpv3 encryption encrypted This command specifies the des encryption protocol and the required encryption key for the specified user. The encryption key must be 8 to 64 characters long. Default Format Mode no encryption username snmpv3 encryption encrypted username des key Global Config show users This command displays the configured user names and their settings. The show users command displays truncated user names. Use the show users long command to display the complete usernames. The show users command is only available for users with read/write privileges. The SNMPv3 fields are displayed only if SNMP is available on the system. Format Mode show users Privileged EXEC Term User Name Access Mode Definition The name the user enters to login using the serial port, Telnet or Web. Shows whether the user is able to change parameters on the switch (Read/Write) or is only able to view them (Read Only). As a factory default, the "admin" user has Read/Write access and the "guest" has Read Only access. Management Commands 107 CLI Command Reference Manual