Netgear XSM4324FS CLI Manual Software Version 12.x - Page 239
The following example shows that the IPv6 traceroute is a success
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter Description interval Use the optional interval parameter to specify the time between probes, in seconds. If a response is not received within this interval, then traceroute considers that probe a failure (printing *) and sends the next probe. If traceroute does receive a response to a probe within this interval, then it sends the next probe immediately. Range is 1 to 60 seconds. count Use the optional count parameter to specify the number of probes to send for each TTL value. Range is 1 to 10 probes. port Use the optional port parameter to specify destination UDP port of the probe. This should be an unused port on the remote destination system. Range is 1 to 65535. size Use the optional size parameter to specify the size, in bytes, of the payload of the Echo Requests sent. Range is 0 to 65507 bytes. source Use the optional source parameter to specify the source IP address or interface for the traceroute. The following are examples of the CLI command. Command example: The following example shows that the traceroute is a success: (NETGEAR Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.240.10.115 ,4 hops max 43 byte packets: 1 10.240.4.1 708 msec 41 msec 11 msec 2 10.240.10.115 0 msec 0 msec 0 msec Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6 Command example: The following example shows that the IPv6 traceroute is a success: (NETGEAR Switch) # traceroute 2001::2 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 2001::2 hops max 43 byte packets: 1 2001::2 708 msec 41 msec 11 msec The above command can also be execute with the optional ipv6 parameter as follows: (NETGEAR Switch) # traceroute ipv6 2001::2 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port 33434 size 43 Command example: The following example shows that the traceroute fails: (NETGEAR Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 10.40.1.1 ,30 hops max 43 byte packets: 1 10.240.4.1 19 msec 18 msec 9 msec 2 10.240.1.252 0 msec 0 msec 1 msec Utility Commands 239 CLI Command Reference Manual