Netgear XSM4324FS CLI Manual Software Version 12.x - Page 487

M4300 Intelligent Edge Series Fully Managed Stackable Switches Format Mode storm-control unicast action {shutdown | trap} Global Config Interface Config no storm-control unicast action This command sets the unicast storm recovery action to the default value for one, several, or all interfaces. If you enter the command in Global Config mode, the action applies to all interfaces. If you enter the command in Interface Config mode, the action applies to or one or more interfaces. Format Mode no storm-control unicast action Global Config Interface Config storm-control unicast level This command configures the unicast storm recovery threshold for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) as a percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold. This command also enables unicast storm recovery mode for an interface. The threshold level can be in the range from 0-100. The default is 5. Default Format Mode 5 storm-control unicast level threshold Global Config Interface Config no storm-control unicast level This command sets the unicast storm recovery threshold to the default value for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) and disables unicast storm recovery. Format Mode no storm-control unicast level Global Config Interface Config Switching Commands 487 CLI Command Reference Manual