Netgear XSM4324FS CLI Manual Software Version 12.x - Page 333

M4300 Intelligent Edge Series Fully Managed Stackable Switches template as the next active template. To list the scaling parameters of a specific template, use that template's keyword as an argument to the command. Use the optional keywords to list the scaling parameters of a specific template. Format Mode show sdm prefer [dual-ipv4-and-ipv6 {data-center-generic | data-center-m4396only | data-center-mixed-native-m4396 | data-center-native} | ipv4-routing data-center {plus-generic | plus-m4396only | plus-mixed-native-m4396 | plus-native}] Privileged EXEC Field ARP Entries IPv4 Unicast Routes IPv6 NDP Entries IPv6 Unicast Routes ECMP Next Hops Description The maximum number of entries in the IPv4 Address Resolution Protocol (ARP) cache for routing interfaces. The maximum number of IPv4 unicast forwarding table entries. The maximum number of IPv6 Neighbor Discovery Protocol (NDP) cache entries. The maximum number of IPv6 unicast forwarding table entries. The maximum number of next hops that can be installed in the IPv4 and IPv6 unicast forwarding tables. Command example: The following example shows the SDM template when the next active SDM template is not changed: (NETGEAR Switch)#show sdm prefer The current template is the 'dual ipv4 and ipv6 data center generic' template. ARP Entries 1536 IPv4 Unicast Routes 512 IPv6 NDP Entries 512 IPv6 Unicast Routes 256 ECMP Next Hops 4 IPv4 Multicast Routes 96 IPv6 Multicast Routes 32 Maximum VLAN Entries 4093 Command example: The following example shows the SDM template when the next active SDM template is configured: (NETGEAR Switch) (Config)#sdm prefer ipv4-routing data-center plus-generic Changes to the running SDM preferences have been stored, but cannot take effect until the next reload. Utility Commands 333 CLI Command Reference Manual