Netgear XSM4324FS CLI Manual Software Version 12.x - Page 656
IP Routing Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 656 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches IP Routing Commands This section describes the commands you use to enable and configure IP routing on the switch. autostate This command enables AutoState for a VLAN routing interface. AutoState changes the state of a VLAN routing interface automatically based on link state events (up or down). By default, AutoState is disabled, which means that a VLAN routing interface could remain up even if the link is down. Format Mode autostate Interface Config no autostate This command disables AutoState for a VLAN routing interface. Format Mode no autostate Interface Config routing This command enables IPv4 and IPv6 routing for an interface or range of interfaces. You can view the current value for this function with the show ip brief command. The value is labeled as Routing Mode. Default Format Mode disabled routing Interface Config no routing This command disables routing for an interface. You can view the current value for this function with the show ip brief command. The value is labeled as Routing Mode. Format Mode no routing Interface Config Routing Commands 656 CLI Command Reference Manual