Netgear XSM4324FS CLI Manual Software Version 12.x - Page 690
set ip precedence, bits, you have eight possible values for the IP precedence
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 690 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches In a route-map statement, the set ip next-hop and set ip default next-hop commands are mutually exclusive. However, the set ip default next-hop command can be configured in a separate route-map statement. Format Mode set ip default next-hop ip-address [...ip-address] Route Map Configuration Parameter ip-address Description The IP address of the next hop to which packets are output. It must be the address of an adjacent router. A maximum of 16 next-hop IP addresses can be specified in this set clause. no set ip default next-hop Use this command to remove a set command from a route map. Format Mode no set ip default next-hop ip-address [...ip-address] Route Map Configuration set ip precedence Use this command to set the three IP precedence bits in the IP packet header. With three bits, you have eight possible values for the IP precedence; value can be a number from 0 through 7. This command is used when implementing QoS and can be used by other QoS services, such as weighted fair queuing (WFQ) and weighted random early detection (WRED). Format Mode set ip precedence value Route Map Configuration Parameter 0 1 2 3 4 5 6 7 Description Sets the routine precedence Sets the priority precedence Sets the immediate precedence Sets the Flash precedence Sets the Flash override precedence Sets the critical precedence Sets the internetwork control precedence Sets the network control precedence Routing Commands 690 CLI Command Reference Manual