Netgear XSM4324FS CLI Manual Software Version 12.x - Page 414
Loop Protection Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 414 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches 1/0/8 0/1/1 0/1/2 0/1/3 0/1/4 0/1/5 0/1/6 Designated Disabled Disabled Disabled Disabled Disabled Disabled Forwarding Disabled Disabled Disabled Disabled Disabled Disabled 3000 3000 3000 3000 3000 3000 3000 128.8 128.1026 128.1027 128.1028 128.1029 128.1030 128.1031 Loop Protection Commands This section describes the commands that you can use to configure loop protection. Loop protection detects physical and logical loops between Ethernet ports on a device. You must enable loop protection globally before you can enable it at the interface level. keepalive (Global Config) This command enables loop protection globally on the switch. As an option, you can configure the time in seconds between the transmission of keep-alive packets (that is, the transmit interval) and the maximum number of keep-alive packets (that is, the packet count) that the switch can receive before an action is taken. Default Format Mode Disabled Interval is 5 seconds Packet count is 1 keepalive [interval] [packet-count] Global Config no keepalive (Global Config) This command disables loop protection globally on the switch. This command also sets the transmit interval and packet count to the default value. Format Mode no keepalive Global Config keepalive (Interface Config) This command enables loop protection on an interface. Default Format Mode Disabled keepalive Interface Config Switching Commands 414 CLI Command Reference Manual