Netgear XSM4324FS CLI Manual Software Version 12.x - Page 835
ipv6 unreachables, ipv6 unresolved-traffic, no ip prefix-list
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 835 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip prefix-list To delete a prefix list or a statement in a prefix list, use the no ip prefix-list command. The no ip prefix-list list-name command deletes the entire prefix list. To remove an individual statement from a prefix list, you must specify the statement exactly, with all its options. Format Mode no ip prefix-list list-name [[seq number] {permit | deny} network/length [ge length] [le length]] Global Configuration ipv6 unreachables Use this command to enable the generation of ICMPv6 Destination Unreachable messages on the interface or range of interfaces. By default, the generation of ICMPv6 Destination Unreachable messages is enabled. Default Format Mode enable ipv6 unreachables Interface Config no ipv6 unreachables Use this command to prevent the generation of ICMPv6 Destination Unreachable messages. Format Mode no ipv6 unreachables Interface Config ipv6 unresolved-traffic Use this command to control the rate at which IPv6 data packets come into the CPU. By default, rate limiting is disabled. When enabled, the rate, expressed by the seconds variable, can range from 50 to 1024 packets per second. Default Format Mode enable ipv6 unresolved-traffic rate-limit seconds Global Config IPv6 Commands 835 CLI Command Reference Manual