Netgear XSM4324FS CLI Manual Software Version 12.x - Page 843

M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter Description Local AS Number The AS number that the local router is in. BGP Admin Mode Whether BGP is globally enabled or disabled. Maximum Paths The maximum number of next hops in an internal or external BGP route. Always Compare Whether BGP is configured to compare the MEDs for routes received from peers in different ASs. MED Maximum AS Path Limit on the length of AS paths that BGP accepts from its neighbors. Length Fast Internal Failover Whether BGP immediately brings down a iBGP adjacency if the routing table manager reports that the peer address is no longer reachable. Fast External Failover Whether BGP immediately brings down an eBGP adjacency if the link to the neighbor goes down. Distance The default administrative distance (or route preference) for external, internal, and locally-originated BGP routes. The table that follows lists ranges of neighbor addresses that have been configured to override the default distance with a neighbor-specific distance. If a neighbor's address falls within one of these ranges, routes from that neighbor are assigned the configured distance. If a prefix list is configured, then the distance is only assigned to prefixes from the neighbor that are permitted by the prefix list. Redistribution A table showing information for each source protocol (connected, static, rip, and ospf). For each of these sources the distribution list and route-map are shown, as well as the configured metric. Fields which are not configured are left blank. For ospf, an additional line shows the configured ospf match parameters. Prefix List In The global prefix list used to filter inbound routes from all neighbors. Prefix List Out The global prefix list used to filter outbound routes to all neighbors. Networks Originated The set of networks originated through a network command. Those networks that are actually advertised to neighbors are marked "active." Neighbors A list of configured neighbors and the inbound and outbound policies configured for each. OSPFv3 Section: Routing Protocol OSPFv3. Router ID The router ID configured for OSPFv3. OSPF Admin Mode Whether OSPF is enabled or disabled globally. Maximum Paths The maximum number of next hops in an OSPF route. Default Route Advertise Whether OSPF is configured to originate a default route. Always Whether default advertisement depends on having a default route in the common routing table. Metric The metric configured to be advertised with the default route. Metric Type The metric type for the default route. IPv6 Commands 843 CLI Command Reference Manual