Netgear XSM4324FS CLI Manual Software Version 12.x - Page 69
ping ipv6 interface, interface, serviceport
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches You can utilize the ping or traceroute facilities over the service or network ports when using an IPv6 global address ipv6-global-address or hostname. Any IPv6 global address or gateway assignments to these interfaces causes IPv6 routes to be installed such that the ping or traceroute request is routed out the service or network port properly. When referencing an IPv6 link-local address, you must specify the interface keyword with either the unit/slot/port argument, vlan keyword and vland-id argument, or serviceport keyword. Use the optional size keyword and datagram-size parameter to specify the size of the ping packet. Default Format Mode The default count is 1. The default interval is 3 seconds. The default size is 0 bytes. ping ipv6 {ipv6-global-address | hostname | {interface {unit/slot/port | vlan vland-id | serviceport} link-local-address} [size datagram-size]} Privileged EXEC User Exec ping ipv6 interface Use this command to determine whether another computer is on the network. To use the command, configure the switch for network (in-band) connection. The source and target devices must have the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path between the switch and the workstation. The terminal interface sends three pings to the target station. You can use a loopback, network port, service port, tunnel, VLAN, or physical interface as the source. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. Use the optional size keyword and datagram-size parameter to specify the size of the ping packet. Format Modes ping ipv6 interface {unit/slot/port | vlan vland-id | loopback loopback-id | serviceport | tunnel tunnel-id} {link-local-address link-local-address | ipv6-address} [size datagram-size] Privileged EXEC User Exec Management Commands 69 CLI Command Reference Manual