Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1033
show ip pim, The following example shows PIM Mode - Sparse
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1033 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Current multicast IPv4 protocol PIMSM Current multicast IPv6 protocol No protocol enabled. Total software forwarded packets 0 Source address: 192.168.10.5 Group address: 225.1.1.1 Packets forwarded in software for this entry: 0 Protocol: PIM-SM Expiry Time (secs): 206 Up Time (secs): 4 Incoming interface: 1/0/10 Outgoing interface list: None show ip pim This command displays the system-wide information for PIM-DM or PIM-SM. Format Modes show ip pim Privileged EXEC User EXEC Note: If the PIM mode is PIM-DM (dense), some of the fields in the following table do not display in the command output because they are applicable only to PIM-SM. Term PIM Mode Interface Interface Mode Operational Status Definition Indicates the configured mode of the PIM protocol as dense (PIM-DM) or sparse (PIM-SM) unit/slot/port Indicates whether PIM is enabled or disabled on this interface. The current state of PIM on this interface: Operational or Non-Operational. The following example shows PIM Mode - Dense: (NETGEAR) #show ip pim PIM Mode Dense Interface --------1/0/1 1/0/3 Interface-Mode Enabled Disabled Operational-Status Operational Non-Operational Command example: The following example shows PIM Mode - Sparse (NETGEAR) #show ip pim IP Multicast Commands 1033 CLI Command Reference Manual