Netgear XSM4324FS CLI Manual Software Version 12.x - Page 869
maximum-paths OSPFv3, passive-interface default OSPFv3, no external-lsdb-limit, no maximum-paths
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 869 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no external-lsdb-limit This command configures the default external LSDB limit for OSPF. Format Mode no external-lsdb-limit Router OSPFv3 Config maximum-paths (OSPFv3) This command sets the number of paths that OSPF can report for a given destination where maxpaths is platform dependent. Default Format Mode 4 maximum-paths maxpaths Router OSPFv3 Config no maximum-paths This command resets the number of paths that OSPF can report for a given destination back to its default value. Format Mode no maximum-paths Router OSPFv3 Config passive-interface default (OSPFv3) Use this command to enable global passive mode by default for all interfaces. It overrides any interface level passive mode. OSPF shall not form adjacencies over a passive interface. Default Format Mode disabled passive-interface default Router OSPFv3 Config no passive-interface default Use this command to disable the global passive mode by default for all interfaces. Any interface previously configured to be passive reverts to nonpassive mode. Format Mode no passive-interface default Router OSPFv3 Config IPv6 Commands 869 CLI Command Reference Manual