Netgear XSM4324FS CLI Manual Software Version 12.x - Page 680

M4300 Intelligent Edge Series Fully Managed Stackable Switches ECMP Routes 1001 Truncated ECMP Routes 0 ECMP Retries 0 Routes with 1 Next Hop 31 Routes with 2 Next Hops 1 Routes with 4 Next Hops 1000 clear ip route This command lets you reset the IPv4 routing table counters or remove various types of routes in the IPv4 routing table. Format Mode clear ip route {all | bgp [ip-address subnet-mask [interface unit/slot/port]] | counters | ospf [ip-address subnet-mask [interface unit/slot/port] | rip [ip-address subnet-mask [interface unit/slot/port]]} Privileged EXEC Term all bgp counters ospf rip Definition Removes all dynamic routes from the IPv4 routing table. Static routes are not removed. Removes all BGP routes from the IPv4 routing table. By using the ip-address and subnet-mask parameters you can remove specific BGP routes. In addition, you can remove specific BGP routes from specific next hop interfaces by using the interface option and unit/slot/port parameter. The command resets the IPv4 routing table counters to zero. These are the IPv4 routing table counters that display in the output of the show ip route summary command (see show ip route summary on page 677). The command resets event counters only. Counters that display in the current state of the routing table, such as the number of routes of each type, are not reset. Removes all OSPF routes from the IPv4 routing table. By using the ip-address and subnet-mask parameters you can remove specific OSPF routes. In addition, you can remove specific OSPF routes from specific next hop interfaces by using the interface option and unit/slot/port parameter. Removes all RIP routes from the IPv4 routing table. By using the ip-address and subnet-mask parameters you can remove specific RIP routes. In addition, you can remove specific RIP routes from specific next hop interfaces by using the interface option and unit/slot/port parameter. show ip route preferences This command displays detailed information about the route preferences for each type of route. Route preferences are used in determining the best route. Lower router preference values are preferred over higher router preference values. A route with a preference of 255 cannot be used to forward traffic. Format Modes show ip route preferences Privileged EXEC User EXEC Routing Commands 680 CLI Command Reference Manual