Netgear XSM4324FS CLI Manual Software Version 12.x - Page 48

M4300 Intelligent Edge Series Fully Managed Stackable Switches boot auto-copy-sw allow-downgrade (for stack firmware synchronization) Use this command to enable downgrading of the firmware version on the stack member if the firmware version on the manager is older than the firmware version on the member. Default Format Mode Enabled boot auto-copy-sw allow-downgrade Privileged EXEC no boot auto-copy-sw allow-downgrade Use this command to prevent downgrading of the firmware version on the stack member if the firmware version on the manager is older than the firmware version on the member. Format Mode no boot auto-copy-sw allow-downgrade Privileged EXEC show auto-copy-sw (for stack firmware synchronization) Use this command to display the stack firmware synchronization configuration status. Format Mode show auto-copy-sw Privileged EXEC Term Definition Synchronization Shows whether the SFS feature is enabled. SNMP Trap Status Shows whether the stack sends traps for SFS events Allow Downgrade Shows wether the stack manager is permitted to downgrade the firmware version of a stack member. Nonstop Forwarding Commands for Stack Configuration You can describe a switch in terms of three semi-independent functions: the forwarding plane, the control plane, and the management plane. The forwarding plane forwards data packets. The forwarding plane is implemented in hardware. The control plane is the set of protocols that determines how the forwarding plane must forward packets, which data packets can be forwarded, and where the data packets must be forwarded to. Stacking Commands 48 CLI Command Reference Manual