Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1066
ipv6 pim rp-address, ipv6 pim rp-candidate
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1066 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches ipv6 pim rp-address This command defines the address of a PIM Rendezvous point (RP) for a specific multicast group range. Note: This command takes effect only when PIM-SM is configured as the PIM mode. Default Format Mode 0 ipv6 pim rp-address rp-address group-address/prefix-length [override] Global Config Parameter rp-address group-address/ prefix-length override Description The IPv6 address of the RP. The group address and prefix length supported by the RP. [Optional] Indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by BSR. no ipv6 pim rp-address This command is used to remove the address of the configured PIM Rendezvous point (RP) for the specified multicast group range. Format Mode no ipv6 pim rp-address rp-address group-address/prefix-length [override] Global Config ipv6 pim rp-candidate This command is used to configure the router to advertise itself as a PIM candidate rendezvous point (RP) to the bootstrap router (BSR) for a specific multicast group range. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter is a number in the range of 1-4093. Note: This command takes effect only when PIM-SM is configured as the PIM mode. IPv6 Multicast Commands 1066 CLI Command Reference Manual