Netgear XSM4324FS CLI Manual Software Version 12.x - Page 941
match source-address mac, match srcip, IP address of a packet.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 941 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode none match [not] protocol {protocol-name | number} Class-Map Config Ipv6-Class-Map Config match source-address mac This command adds to the specified class definition a match condition based on the source MAC address of a packet. The address parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The macmask parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (that is, ff:07:23:ff:fe:dc). Use the not option to negate the match condition. Default Format Mode none match [not] source-address mac address macmask Class-Map Config Ipv6-Class-Map Config match srcip This command adds to the specified class definition a match condition based on the source IP address of a packet. The ipaddr parameter specifies an IP address. The ipmask parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits. Use the not option to negate the match condition. Default Format Mode none match [not] srcip ipaddr ipmask Class-Map Config match srcip6 This command adds to the specified class definition a match condition based on the source IP address of a packet. Use the not option to negate the match condition. Default Format Mode none match [not] srcip6 source-ipv6-prefix/prefix-length Ipv6-Class-Map Config Quality of Service Commands 941 CLI Command Reference Manual