D-Link DGS-3130 Emulator - Page 114
server RADIUS
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, no server is configured. Command Mode Global Configuration Mode. Command Default Level Level: 15. Usage Guideline Use this command to create RADIUS server hosts before it can be associated with the RADIUS server group using the server command. Example This example shows how to create two RADIUS server hosts with the different IP address. Switch#configure terminal Switch(config)# radius-server host 172.19.10.100 auth-port 1500 acct-port 1501 timeout 8 retransmit 3 key ABCDE Switch(config)# radius-server host 172.19.10.101 auth-port 1600 acct-port 1601 timeout 3 retransmit 1 key ABCDE Switch(config)# 8-24 server (RADIUS) This command is used to associate a RADIUS server host with a RADIUS server group. Use the no form of this command to remove a server host from the server group. server {IP-ADDRESS | IPV6-ADDRESS} no server {IP-ADDRESS | IPV6-ADDRESS} Parameters IP-ADDRESS IPV6-ADDRESS Specifies the IPv4 address of the authentication server. Specifies the IPv6 address of the authentication server. Default By default, no server is configured. Command Mode RADIUS Group Server Configuration Mode. Command Default Level Level: 15. Usage Guideline Use this command to enter the RADIUS group server configuration mode. Use the server command to associate the RADIUS server hosts with the RADIUS server group. The defined server group can be specified as the method 110