D-Link DGS-3130 Emulator - Page 502

Parameters all INTERFACE-ID , - DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Specifies to clear LLDP neighboring information for all interfaces. Specifies the interface ID. Valid interfaces are physical interfaces. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. Command Mode Privileged EXEC Mode. Command Default Level Level: 12. Usage Guideline If this command is issued without the interface keyword, all neighboring information on all interfaces will be cleared. Example This example shows how to clear all neighboring information on all interfaces. Switch# clear lldp table all Switch# 48-3 lldp dot1-tlv-select This command is used to specify which optional type-length-value settings (TLVs) in the IEEE 802.1 organizationally specific TLV set will be transmitted and encapsulated in LLDPDUs, and sent to neighbor devices. Use the no form of this command to disable the transmission of TLVs. lldp dot1-tlv-select {port-vlan | protocol-vlan VLAN-ID [, | -] | vlan-name [VLAN-ID [, | -]] | protocol-identity [PROTOCOL-NAME]} no lldp dot1-tlv-select {port-vlan | protocol-vlan [VLAN-ID [, | -]] | vlan-name [VLAN-ID [, | -]] | protocolidentity [PROTOCOL-NAME]} Parameters port-vlan protocol-vlan VLAN-ID Specifies the port VLAN ID TLV to send. The Port VLAN ID TLV is an optional fixed length TLV that allows a VLAN bridge port to advertise the port VLAN identifier (PVID) that will be associated with untagged or priority tagged frames. Specifies the Port and Protocol VLAN ID (PPVID) TLV to send. The PPVID TLV is an optional TLV that allows a bridge port to advertise a port and protocol VLAN ID. Specifies the ID of the VLAN in the PPVID TLV. The VLAN ID range is 1 to 4094. If no VLAN ID is specified, all configured PPVID VLANs will be cleared and no PPVID TLV will be sent. 498