D-Link DGS-3130 Emulator - Page 718
ipv6 router rip
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 718 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Default By default, this value is 1. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The metric refers to the hop count. By default, when receiving an IPv6 RIP route, a metric value of 1 is added to the route before it is inserted into the routing table. Use this command to influence the metric of routes received on different interface and thus influence the preference of the route. Example This example shows how to configure a metric increment of 3 for routes received on VLAN 1. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# ipv6 rip metric-offset 3 Switch(config-if)# 69-6 ipv6 router rip This command is used to configure the IPv6 RIP routing process. Use the no form of this command to remove an IPv6 RIP routing process. ipv6 router rip no ipv6 router rip Parameters None. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline This command is used to enter the Router Configuration Mode for IPv6 RIP routing process. Use the no form of the command to remove an IPv6 RIP routing process. 714