D-Link DGS-3130 Emulator - Page 138

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline When the neighbor host receives the RA which has flag turned on, the host should use a stateful configuration protocol to obtain IPv6 addresses. Example This example shows how to turn on the IPv6 management configure flag in RA advertised on VLAN 1. Switch# configure terminal Switch(config)# interface vlan 1 Switch(config-if)# ipv6 nd managed-config-flag Switch(config-if)# 10-10 ipv6 nd other-config-flag This command is used to turn on the other configuration flag in the advertised RA message. Use the no form of this command to turn off the flag. ipv6 nd other-config-flag no ipv6 nd other-config-flag Parameters None. Default By default, this feature is disabled. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline By setting the other configuration flag on, the router instructs the connected hosts to use a stateful configuration protocol to obtain auto-configuration information other than the IPv6 address. Example This example shows how to turn on the other configuration flag. 134