D-Link DGS-3130 Emulator - Page 211

Parameters DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide HARDWARE-ADDRESS Specifies the MAC address of the client. Default None. Command Mode DHCP Pool Configuration Mode. Command Default Level Level: 12. Usage Guideline A binding entry is a mapping between the IP address and the hardware address or the client identifier. By creating a manual binding entry, an IP address is manually assigned to a client. Only one manual binding entry can be specified in a DHCP address pool. With a binding entry, the IP address can be either bound with a client identifier or bound with the hardware address of the host. Use the client-identifier command and the host command to specify the manual binding entry based on client identifier in the DHCP packet. Use the hardware-address command and the host command to specify the manual binding entry based on hardware address. Example This example shows how a DHCP address pool "pool1" is created with a manual binding entry which binds the IP address 10.1.2.100/24 with the MAC address C2:F3:22:0A:12:F4. Switch# configure terminal Switch(config)# ip dhcp pool pool1 Switch(config-dhcp-pool)# hardware-address C2F3.220A.12F4 Switch(config-dhcp-pool)# host 10.1.2.100/24 Switch(config-dhcp-pool)# 19-12 host This command is used to specify the IP address of the manual binding entry in a DHCP address pool. Use the no form of this command to remove the specification of the IP address from the entry. host {IP-ADDRESS MASK | IP-ADDRESS/PREFIX-LENGTH} no host Parameters IP-ADDRESS MASK PREFIX-LENGTH Specifies the IP address of the manual binding entry. Specifies the bits that mask the network part of the host address. Specifies the prefix length of the network. It is an alternative way to specify the network mask. Default None. 207