D-Link DGS-3130 Emulator - Page 554
ipv6 mld snooping limit
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 554 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 52-6 ipv6 mld snooping limit This command is used to set the limit of MLD snooping multicast groups or channels which layer 2 interface can join. Use the no form of this command to remove the limitation. ipv6 mld snooping limit NUMBER [exceed-action {drop | replace}] [except IPv6-ACCESS-LIST-NAME] [vlan VLAN-ID] no ipv6 mld snooping limit [vlan VLAN-ID] Parameters NUMBER exceed-action drop replace except IPv6-ACCESSLIST-NAME vlan VLAN-ID Specifies the maximum number of MLD snooping groups that the interface can join. This value must between 1 and 4096. (Optional) Specifies the action for handling newly learned groups when the limitation is exceeded. (Optional) Specifies that the new group will be dropped. (Optional) Specifies that the new group will replace the oldest group. (Optional) Specifies a standard IPv6 access list. The group (*,G) or channel (S,G) permitted in the access list will be excluded from the limit. To permit a channel (S,G), S is specified in the source address field and G is specified in the destination address field of the access list entry. To permit a group (*,G), "any" is specified in the source address field and G is specified in the destination address field of the access list entry. (Optional) Specifies a Layer 2 VLAN and applies the filter to packets that arrive on that VLAN. Default By default, there is no limit. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline The command is available for physical port or port-channel interface configuration. Example This example shows how to set the limit of MLD snooping groups that ethernet 1/0/4 with VLAN ID 1000 can join and specify the "mld_filter" access list to be excluded from the limit. Switch# configure terminal Switch(config)# interface ethernet 1/0/4 Switch(config-if)# ipv6 mld snooping limit 80 except mld_filter vlan 1000 Switch(config-if)# This example shows how to remove the limit of MLD snooping groups that port-channel 4 with VLAN ID 1000 can join. 550