D-Link DGS-3130 Emulator - Page 41

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide show dot1x session-statistics [interface INTERFACE-ID [, | -]] Parameters interface INTERFACE-ID , - (Optional) Specifies to display the dot1x diagnostics on the specified interface or range of interfaces. If not specified, information about all interfaces will be displayed. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. (Optional) Specifies a range of interfaces. No space is allowed before or after the hyphen. Default None. Command Mode User/Privileged EXEC Mode. Any Configuration Mode. Command Default Level Level: 1. Usage Guideline This command can be used to display 802.1X session statistics. If no optional parameter is specified, information of all interfaces will be displayed. Example This example shows how to display dot1X session statistics on Ethernet port 1/0/1. Switch# show dot1x session-statistics interface ethernet 1/0/1 eth6/0/1 session statistic counters are following: SessionOctetsRX : 0 SessionOctetsTX : 0 SessionFramesRX : 0 SessionFramesTX : 0 SessionId : SessionAuthenticationMethod : Remote Authentication Server SessionTime : 0 SessionTerminateCause :SupplicantLogoff SessionUserName : Switch# 3-16 snmp-server enable traps dot1x This command is used to enable the sending of SNMP notifications for 802.1X authentication. Use the no form of this command to disable the sending of SNMP notifications. snmp-server enable traps dot1x no snmp-server enable traps dot1x 37