D-Link DGS-3130 Emulator - Page 881

DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# protocol-vlan profile 10 frame-type ethernet2 ether-type 0x86dd Switch(config)# 89-5 protocol-vlan profile (Interface) This command is used to configure the VLAN classification entry for a protocol group on a port. Use the no form of this command to remove the VLAN classification entry on a port. protocol-vlan profile PROFILE-ID vlan VLAN-ID [priority COS-VALUE] no protocol-vlan profile PROFILE-ID Parameters PROFILE-ID vlan VLAN-ID priority COS-VALUE Specifies the ID of the protocol group to be classified. Specifies the VLAN ID of the protocol VLAN. Only one VLAN ID can be specified for each binding group. (Optional) Specifies the priority CoS value. If not specified, the default COS is 0. Default None. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this to specify a VLAN for a protocol group on a port. As a result, the packet received by the port that matches the specified protocol group will be classified to the specified VLAN. The VLAN does not need to exist to configure the command. The precedence for classifying the untagged packet is MAC-based > Subnet-based > Protocol VLAN. Example This example shows how to create a VLAN classification entry on Ethernet 1/0/1 to classify packets in the protocol group 10 to VLAN 3000. Switch# configure terminal Switch(config)# interface ethernet 1/0/1 Switch(config-if)# protocol-vlan profile 10 vlan 3000 Switch(config-if)# 89-6 show protocol-vlan profile This command is used to display the configuration settings of the protocol VLAN related setting. 877