D-Link DGS-3130 Emulator - Page 827
storm-control polling, show storm-control
![]() |
View all D-Link DGS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 827 highlights
DGS-3130 Layer 3 Stackable Managed Switch CLI Reference Guide 80-3 storm-control polling This command is used to configure the polling interval of received packet counts. Use the no form of this command to revert to the default settings. storm-control polling {interval SECONDS | retries {NUMBER | infinite}} no storm-control polling {interval | retries} Parameters interval SECONDS retries NUMBER Specifies the polling interval of received packet counts. This value must be between 1 and 300 seconds. Specifies the retry count. If the action is configured to the shutdown mode and a storm continues as long as the interval times retries values set, the port will enter the error disabled state. This value must be between 0 and 360. 0 means that a shutdown mode port will directly enter the error disabled state when a storm is detected. Infinite means that a shutdown mode port will never enter the error disabled state even if a storm was detected. Default The default polling interval is 5 seconds. The default retries count value is 3. Command Mode Global Configuration Mode. Command Default Level Level: 12. Usage Guideline Use this to specify the sample interval of received packet counts. Example This example shows how to specify the polling interval as 15 seconds. Switch# configure terminal Switch(config)# storm-control polling interval 15 Switch(config)# 80-4 show storm-control This command is used to display the current storm control settings. show storm-control interface INTERFACE-ID [, | -] [broadcast | multicast | unicast] Parameters interface INTERFACE-ID , Specifies the port's interface ID. (Optional) Specifies a series of interfaces or separates a range of interfaces from a previous range. No space is allowed before or after the comma. 823
![](/manual_guide/products/dlink-dgs3130-emulator-9c3be7f/827.png)